Toyota 4Runner 5VZ-FE Throttle Body Spacer Installation
- 2020.11.01
- 4Runner, 5VZ-FE, Installation, Throttle body spacer, TOYOTA
Since the throttle spacer for 5VZ-FE is not sold in Japan, I personally imported the one made by AIRAID from overseas. The contents are as follows.・Spacer body・2 gaskets・Mounting bolts・Promotional stickers・Instructions (not shown in the photo) The work is easy. Remove the throttle from the engine side. Of course, the throttle cannot be removed unless the air intake is removed. Don’t forget the various wires. Install the throttle spacer on the removed throttle side. Don’t forget to install the attached gasket at this time. Then put it back. Since the wire will be pulled by the amount of the spacer, actually step on the accelerator to adjust the play. I think this is all right. Completed by restoring the removed air intake. When I ran after installing it, the response improved dramatically! Since the amount of depression of the accelerator has decreased, fuel efficiency has also improved. I think that it is a part that can be installed without any loss.