Toyota 86 How to Remove the Rear Seat

The rear seats will be removed to reduce weight when driving on the circuit. Putting myself in my car and riding three people is only a few times, so there is no particular problem. As for the noise, I always knocked down the rear seat to make it look like a 2-seater, so the sound does not change so much even if the road noise becomes a little louder. I hope the fuel economy will also improve.

First of all, how to remove the seat. Remove the white circle bolt with a 10 mm socket wrench. (Tightening torque 13N • m)

Next, lift the white circle and push the arrow down. Then it will come off.

Next is the backrest. First, tilt the backrest and remove the trunk board. Since there is a clip in the part of the picture, you can pull it out, or you can leave the clip on the car side and remove it from the seat as shown in the picture.

There are 3 clips in the white circle.

Remove the clip and turn it over to see the bolt. Remove it with a 12 mm socket. The photo is on the right side, but the same is true on the left side. (Tightening torque 33N • m)

Raise the rear seat slowly so that the upper lock is not applied. If you put your hand in the part of the arrow in the photo and pull it toward you, it will come off, so change the direction and take it out of the trunk.

done. It’s lighter, but it doesn’t fit in the front seats, so when I have time, I’ll try to make it look like a 14R-60. I’m thinking of putting a mat on the back part and installing a fake backrest.

By the way, this is a picture of the rear seat of 14R-60. I want to make it look like this.