Rear│JPNMotors

Toyota 86 How to Remove the Rear Seat

2021.05.04
86, BRZ, FR-S, Rear, Remove, Scion, Seat, Subaru, TOYOTA

The rear seats will be removed to reduce weight when driving on the circuit. Putting myself in my car and riding three people is only a few times, so there is no particular problem. As for the noise, I always knocked down the rear seat to make it look like a 2-seater, so the sound does not change so much even if the road noise becomes a little louder. I hope the fuel economy will also improve. First of all, how to remove the seat. Remove the white circle bolt with a 10 mm socket wrench. (Tightening torque 13N • m) Next, lift the white circle and push the arrow down. Then it will come off. Next is the backrest. First, tilt the backrest and remove the trunk board. Since there is a clip in the part of the picture, you can pull it out, or you can leave the clip on the car side and remove it from the seat as shown in the picture. There are 3 clips in the white circle. Remove the clip and turn it over to see the bolt. Remove it with a 12 mm socket. The photo is on the right side, but […]

Honda CR-Z How to Remove the Rear Bumper

Fiddling

2021.04.25
Bumper, CR-Z, Honda, Rear, Remove

First, put a protective covering on the body. Remove the two screws from the tire house. There are a total of 4 on the left and right. Remove the hexagonal screw where the hatch was opened. There are a total of 2 on the left and right. Remove the screw underneath and remove the clip that stays on the body. There are a total of 2 screws on the left and right, and 4 clips. Now that there is nothing to hold the bumper in, pull it out. However, the license plate was caught and could not be removed. The license plate pops up when you remove the hook (red arrow) that holds the bottom side. Then, dodge the gap in the bumper and remove it. And don’t forget to remove the coupler of the license plate light. The removal is completed successfully.